基于QSSP的震源破裂过程反演方法     

王博文  张燕  申重阳  谈洪波 《大地测量与地球动力学》2022,42(10):1074-1079

在Qt平台上,基于QSSP软件,利用C⁺⁺进行地震破裂过程反演方法研究。采用按阶段反演的方法,第1阶段反演采用热浴算法进行全局搜索,先按断层区域的构造背景等初始条件对参数范围进行划取,在该范围内随机给定一组初始值开始迭代,使波形初步拟合避开局部最优解;第2阶段反演使用拟牛顿法进行快速收敛,提高波形拟合程度,迭代至目标函数小于误差条件时停止,输出满足误差条件的待解模型参数。为避免模型参数出现病态问题,使用拉普拉斯方程建立平滑矩阵并引入平滑因子对断层模型进行平滑约束。使用棋盘模型验证该方法的稳定性和可靠性。最后,将全国13个台站的重力数据积分后对2013-04-20芦山7.0级地震的破裂过程进行反演,并与其他研究结论进行对比分析。  相似文献   

���ݵ�������ѵ���ֵģ��     

李红  陈连旺  李玉江 《大地测量与地球动力学》2008,28(2):39-44

?????????????????????????????????????GPS????????????????????????????????????????4?????????????????????????????????????????????????????????????????????????壻??????????????????????????????????????????壻?齭???????????????????????????????????塣???????????????????????ζ?????????????????????????????????????????????κ??齭???????????????????????????????????????????????  相似文献   

�봨8������ر����Ѵ��������乹������   总被引：7，自引：2，他引：5  

任俊杰  张世民 《大地测量与地球动力学》2008,28(6):47-52

???ò??GPS????8????????????????????????????????????????????????????????:?????????-?????????γ?????200 km???????????????????????-????????????γ?????75 km??????????????????????????????????????????????????????????????????????????????????????????????  相似文献   

Simultaneous inversion of waveform and geodetic data for the rupture process of the 1984 Naganoken–Seibu, Japan, earthquake     

Shingo Yoshida  Kazuki Koketsu 《Geophysical Journal International》1990,103(2):355-362

  相似文献   

Finite element analysis of land subsidence above depleted reservoirs with pore pressure gradient and total stress formulations     

Giuseppe Gambolati  Massimiliano Ferronato  Pietro Teatini  Roberto Deidda  Giuditta Lecca 《国际地质力学数值与分析法杂志》2001,25(4):307-327

The solution of the poroelastic equations for predicting land subsidence above productive gas/oil fields may be addressed by the principle of virtual works using either the effective intergranular stress, with the pore pressure gradient regarded as a distributed body force, or the total stress incorporating the pore pressure. In the finite element (FE) method both approaches prove equivalent at the global assembled level. However, at the element level apparently the equivalence does not hold, and the strength source related to the pore pressure seems to generate different local forces on the element nodes. The two formulations are briefly reviewed and discussed for triangular and tetrahedral finite elements. They are shown to yield different results at the global level as well in a three‐dimensional axisymmetric porous medium if the FE integration is performed using the average element‐wise radius. A modification to both formulations is suggested which allows to correctly solve the problem of a finite reservoir with an infinite pressure gradient, i.e. with a pore pressure discontinuity on its boundary. Copyright © 2001 John Wiley & Sons, Ltd.  相似文献   

汶川大地震（MS 8.0）同震变形作用及其与地质灾害的关系   总被引：12，自引：2，他引：10  

付小方  侯立玮  李海兵  王宗秀  邹付戈 《地质学报》2008,82(12):1733-1746

2008年5月12日发生于四川盆地西部龙门山断裂带的汶川大地震（MS 8.0）波及半个亚洲,震撼整个中国。本文通过地震后的实地调查,对发育在龙门山断裂带上的同震地表破裂带的分布、产状、继承性复活与变形特征,以及同震变形与地震地质灾害的关系等进行了初步总结,分析表明这次汶川大地震(MS 8.0)沿北川-映秀逆冲断裂和安县-灌县逆冲断裂同时发生地表破裂,前者产生以高角度逆冲兼右旋走滑为特征的地表破裂带长约275 km,后者产生以缓倾角逆冲作用为特征的地表破裂带长约80 km。汶川大地震的同震地表破裂带分布具有分段性特征,并与地表破坏程度的分带性有着一定的内在联系,详细研究表明,同震地表破裂带的产状直接影响地表破坏程度和地震地质灾害的强度,汶川大地震（MS 8.0）沿呈高角度陡倾的北川-映秀逆冲断裂发育的同震地表变形所产生的地表破坏程度和地震地质灾害的强度比沿缓倾角的安县-灌县逆冲断裂要强。从各种类型的地震断裂来看,具有垂直运动的逆冲型地震断裂所造成的地表破坏程度和地质灾害强度比具水平运动的走滑型地震断裂要强。因此,汶川大地震发生的破裂过程和同震地表变形与地震地质灾害的关系值得深入研究。  相似文献   

山区合适耕地经营规模确定的实证研究——以重庆市为例   总被引：1，自引：0，他引：1  

范乔希  邵景安  应寿英 《地理研究》2018,37(9):1724-1735

在地形起伏、地块破碎、分布半径较远等约束下,山区多大的经营规模是合适的?这是目前必须弄清的科学问题之一。使用480份有效调查问卷,以投入农业的劳动力为测算单位,以劳均纯收入为评价指标,分作物类型和地块分布半径,构建计量经济模型,测算不同条件下合适的耕地经营,结果表明：① 在现有社会经济条件下,样本村农业土地适度规模经营面积为24~32亩,适度规模下的劳均纯收入远高于当前农村人均纯收入,且与城镇居民的差距明显缩小。② 作物类型对适度规模影响不大,但对农民纯收入产生较大作用。经济作物和粮食作物的适度规模分别为24.33亩、24.63亩,差异不显著,但种植经济作物和粮食作物在适度规模下的劳均纯收入相差3638元,巨大的差距将促使经济作物种植面积不断扩大。③ 距离对适度规模影响较大,但对劳均纯收入影响不大。0.5 km内、0.5~1 km的适度规模分别为28.62亩、31.83亩,单位劳动力的适度规模相差3亩,这表明距离是目前从事农业生产时劳动力投入时须考虑的重要因素。但是,对应的劳均纯收入相差较小,又说明伴随耕作距离的增加,更多的投入主要依靠机械来完成,从而带动适度规模的扩大。1 km外的建模未通过检验,也进一步说明未实现规模经营、没有进行机械化耕作、离家远的土地收支严重不平衡,撂荒严重,规模化经营、机械化耕作是解决距离问题的有效途径。本文得出的土地适度规模是可行的,也验证了推进土地适度规模经营的可行性和必要性。  相似文献   

冰盖下矩形河道的综合糙率          下载免费PDF全文

陈刚  张玉蓉  周密  顾世祥 《水科学进展》2016,27(2):290-298

综合糙率是采用曼宁公式确定河道水位和流量关系的关键参数。在河道冰封期,冰盖的出现增加了流动的阻力,明流条件下确定的综合糙率不再适用,需要重新估算。基于Einstein阻力划分过流断面的原理,冰盖下矩形河道的过水断面可划分为冰盖区、河床区和边壁区。根据总流的连续性方程,在确定各分区糙率系数、水力半径和断面面积的基础上,提出了冰盖下矩形河道综合糙率的计算公式。采用已有的试验水槽测量数据和天然河道实测资料对公式进行了验证,结果表明:公式计算的综合糙率与实测值吻合较好,与Einstein公式和Sabaneev公式相比,计算精度更高;对于冰封水流,宽浅河道采用分区水深代替水力半径进行简化计算的条件有别于明渠水流,在宽深比大于20时,计算结果才满足精度要求。  相似文献   

全珊瑚骨料海水混凝土力学性能试验研究   总被引：3，自引：1，他引：2       下载免费PDF全文

糜人杰  余红发  麻海燕  达波  袁银峰  张小平  朱海威  窦雪梅 《海洋工程》2016,34(4):47-54

为了探讨全珊瑚骨料海水混凝土的基本力学性能,并比较其与普通混凝土和轻集料混凝土的差异,通过实验系统测定了珊瑚混凝土的基本力学性能,建立了其轴心抗压强度(f_(c,m))、劈裂抗拉强度(f_(sp,m))、抗折强度(f_(t,m))与立方体抗压强度(f_(cu,m))之间的线性关系与计算公式。结果表明:在强度等级C20~C50的范围内,珊瑚混凝土的f_(c,m)和f_(sp,m)分别比普通混凝土的f_(c,m)和f_(sp,m)高出10%~48%和9%~33%,随着强度等级的提高,两种混凝土之间的差距在减小。珊瑚混凝土的f_(t,m)与普通混凝土的ft,m之间的差异规律与强度等级有关,较低强度等级的C30珊瑚混凝土ft,m比普通混凝土的f_(t,m)要高4%,而较高强度等级的C55珊瑚混凝土f_(t,m)比普通混凝土的f_(t,m)低13%。较高强度等级的C50珊瑚混凝土f_(c,m)、f_(sp,m)和f_(t,m)分别比页岩陶粒轻集料混凝土的f_(c,m)、f_(sp,m)和f_(t,m)低11%、0.9%和4%。  相似文献   

Geological control factors of micro oil distribution in tight reservoirs     

《Marine and Petroleum Geology》2016

Understanding the oil distribution characteristics in unconventional tight reservoirs is crucial for hydrocarbon evaluation and oil/gas extraction from such reservoirs. Previous studies on tight oil distribution characteristics are mostly concerned with the basin scale. Based on Lucaogou core samples, geochemical approaches including Soxhlet extraction, total organic carbon (TOC), and Rock-Eval are combined with reservoir physical approaches including mercury injection capillary pressure (MICP) and porosity-permeability analysis, to quantitatively evaluate oil distribution of tight reservoirs on micro scale. The emphasis is to identify the key geological control factors of micro oil distribution in such tight reservoirs. Dolomicrites and non-detrital mudstones have excellent hydrocarbon generation capacity while detritus-containing dolomites, siltstones, and silty mudstones have higher porosity and oil content, and coarser pore throat radius. Oil content is mainly controlled by porosity, pore throat radius, and hydrocarbon generation capacity. Porosity is positively correlated with oil content in almost all samples including various lithologies, indicating that it is a primary constraint for providing storage space. Pore throat radius is also an important factor, as oil migration is inhibited by the capillary pressure which must be overcome. If the reservoir rock with suitable porosity has no hydrocarbon generation capacity, pore throat radius will be decisive. As tight reservoirs are generally characterized by widely distributed nanoscale pore throats and high capillary pressure, hydrocarbon generation capacity plays an important role in reservoir rocks with suitable porosity and fine pore throats. Because such reservoir rocks cannot be charged completely. The positive correlation between hydrocarbon generation capacity and oil content in three types of high porosity lithologies (detritus-containing dolomites, siltstones, and silty mudstones) supports this assertion.  相似文献